Qlima S(C) 33xx - Piping Installation; Piping Exit Possibilities; Mounting Installation Plate

51
4
51
6. POSSIBILITIES FOR INSTALLING THE PIPING FROM THE INTERIOR UNIT TO
THE EXTERIOR UNIT.
• The piping can be connected exiting from the left rear or right rear of the interior unit. Remove the
left or right breakout plate. See figure 7.
• The piping can be connected exiting from the left rear or right rear. See figure 7.
Figure 7
Cover for the right
piping
Cover for the left
piping
Cover for the piping
Right piping
Left piping
Left back piping
7. MOUNTING THE INSTALLATION PLATE AND MAKING THE PIPING
FEEDTHROUGH.
7.1 Mounting the installation plate of the interior unit.
WARNING!
Use a pipe detector to detect electrical conduits and pipes in the wall before drilling the required
holes to prevent unnecessary damage to the wall or dangerous situations.
a. Fit the installation plate  horizontally on structural parts of the wall with spaces around the instal-
lation plate. See figure 8.