5 – Diagnostics/Troubleshooting
Power-On Self Test Diagnostics
5-6 59225-00 B
S
c. Activate binary mode and copy the configuration file from the
workstation to the switch. The configuration file must be named
"configdata".
ftp>bin
ftp>put configdata
d. Close the FTP session.
ftp>quit
e. Establish communications with the switch using Telnet. Enter one of
the following on the command line:
telnet xxx.xxx.xxx.xxx
or
telnet switchname
where xxx.xxx.xxx.xxx is the switch IP address and switchname is the
switch name associated with the IP address.
f. A Telnet window opens prompting you for a login. Enter an account
name and password. The default account name and password are
(admin, password).
g. Open an admin session to acquire the necessary authority.
SANbox $>admin start
h. Restore the configuration file. When the restore is complete, the switch
will reset.
SANbox (admin) $>config restore
To Next Page
Loading...
Need help?
General
