QNAP TL-D400S User Manual

3. Hardware Installation
This section provides information on installing drives and connecting the JBOD enclosure to a NAS or
computer.
Drive Installation
QNAP JBOD enclosures are compatible with 3.5-inch and 2.5-inch hard drives and 2.5-inch solid-state
drives.
Installing 3.5-inch Drives on 3.5-inch Trays
Warning
Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the JBOD enclosure.
2. Remove a drive tray.
a. Optional: Unlock the tray.
Note
The preinstalled drive trays come unlocked.
Important
Ensure that the drive tray keys are stored in a safe place.
b. Pull the handle to release the tray.
c. Pull the tray out.
QNAP JBOD Enclosure User Guide
Hardware Installation 13

QNAP TL-D400S Specifications

General

Hot-swap	Yes
Storage drive size	2.5/3.5 \
Total installed storage capacity	0 TB
Number of storage drives supported	4
Supported storage drive interfaces	Serial ATA II, Serial ATA III
USB connectivity	No
Fan diameter	120 mm
Product type	HDD/SSD enclosure
Product color	Black, Grey
LED indicators	Fan fail, HDD, Link
Number of fans	1 fan(s)
Noise level	20.1 dB
Data transfer rate	6 Gbit/s
Power source type	AC
AC adapter frequency	50/60 Hz
AC adapter input voltage	100 - 240 V
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	5 - 95 %
Cables included	AC, MiniSAS
Harmonized System (HS) code	84733080

Weight and Dimensions

Depth	219 mm
Width	160.2 mm
Height	168.5 mm
Weight	3660 g