3. Installation and Configuration
This chapter provides specific hardware and firmware installation and configuration steps.
Hardware Installation
This section provides information on installing drives, memory modules, and expansion cards.
Drive Installation
The TS-251B is compatible with 3.5-inch and 2.5-inch hard drives and 2.5-inch solid-state drives.
Installing 3.5-inch Hard Drives on 3.5-inch Trays
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
1. Power off the NAS.
2. Remove the front cover.
a. Locate the lock on the left side of the NAS.
b. Slide the lock down to release the cover.
c. Slide the cover to the left.
d. Remove the cover.
TS-251B User Guide
Installation and Configuration 11
To Next Page
Loading...
