QNAP TS-AI642 Repair Manual

b. Remove the screws that secure the drive cage to the system board.
Note
• The at head D3x4 screws require a Phillips #2 screwdriver.
• A torque of 5 kgf.cm (4.34 lbf.in) ± 0.5 kgf.cm (0.43 lbf.in) is recommended for
electric screwdrivers.
c. Tilt the rear end of the tray up by about 20 degrees.
d. Lift the tray out of the chassis base.
| NAS Repair Manual
Category B NAS Models 44

QNAP TS-AI642 Specifications

General

Brand	QNAP
Model	TS-AI642
Category	Storage
Language	English