4. Power on the SATA JBOD expansion unit.
5. Power on the NAS.
6. Verify that the expansion unit is recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion unit is listed.
Connecting USB expansion units
To connect the device to a USB expansion unit, a USB Type-A to USB Type-C cable is required.
1. Verify that the NAS is powered o.
2. Connect the expansion unit to the NAS.
a. Connect the USB cable to the USB Type-C port on the expansion unit.
b. Connect the USB cable to a USB 3.2 Gen 2 Type-A port on the NAS.
TS-AI642 User Guide
Installation and Conguration 28
To Next Page
Loading...
Need help?
General
