4. NAS Migration
You can migrate data and settings from your current NAS to another NAS model with minimal disruptions
by installing all the hard drives from the source NAS to the destination NAS. RAID conguration and other
settings are retained on the destination NAS after migration.
NAS migration requirements
You can only migrate drives to specic NAS models, depending on your source NAS. For the list of NAS
models compatible with direct NAS migration, see https://www.qnap.com/go/nas-migration.
Your device must meet the following requirements:
• QTS NAS supports several types of NAS migration:
• ARM NAS to an ARM NAS
• x86 NAS to an x86 NAS
• ARM NAS to an x86 NAS
Note
You cannot migrate from an x86 NAS to an ARM NAS.
• The destination NAS must run on the same QTS version as the source NAS (or later).
Important
Due to incompatibilities in le system, system migration between QTS NAS and QuTS hero NAS
is not supported.
Warning
Migrating drives between QTS NAS and QuTS hero NAS can cause data corruption.
• The destination NAS must have sucient free drive bays to accommodate all the drives that you are
migrating from the source NAS.
For NAS models that do not support NAS migration, you can migrate existing data using HBS 3. For details,
see Migrating NAS data using HBS 3.
Status and setting changes after NAS migration
The status of NAS data and settings varies after migration.
Data and Settings After NAS Migration
Registered myQNAPcloud name Your registered myQNAPcloud name is not migrated.
Encrypted disk volumes If the NAS does not support le system encryption, encrypted disk
volumes are not migrated.
Warning
To prevent data loss, back up and save the encryption
keys of encrypted disk volumes in a safe place. You can
also choose to decrypt disk volumes before migration.
TS-AI642 User Guide
NAS Migration 42
To Next Page
Loading...
Need help?
General
