QNAP TS-AI642 - QTS Installation

Note
This image shows the TS-AI642 connected to two TR-004U USB expansion units.
3. Power on the expansion units.
4. Power on the NAS.
5. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
QTS installation
The NAS uses the QNAP QTS operating system. You can install QTS using any of the following methods.
Method Description Requirements
Qnder Pro installation
(Recommended)
If the NAS is connected to your local area
network, you can do the following:
• Locate the NAS using Qnder Pro.
• Complete the steps in the Smart
Installation Guide wizard.
For details, see Initializing QTS using
Qnder Pro.
• Computer
• Network cable
• Qnder Pro installer
TS-AI642 User Guide
Installation and Conguration 29