Frequently Asked Questions
System check list:
AnswerQuestion...
Look at the credit counter at the bottom of the screen,
or:
Press and enter 1 to check your credit balance.
To add credit, see How to Add Credit to the PSD on
page 83.
Do I have enough postage?
Clear batch counters if you intend to issue a report
on the mail run you are about to start (see Batch Data
Report on page 117).
Select Reset counter on the home screen, or
See How to Reset Batch Counters on page 75.
Do I need to clear the Batch
Counter?
For sealing while printing the envelopes.
For sealer-equipped feeders, see How to Fill the
Sealer Bottle on page 203.
Is the sealing/moistening device
properly filled?
(if installed)
Before laying envelope(s) on the Weighing Platform,
your Home Screen should display 0 g. If _g is dis-
played, perform a 'rezero' of the WP.
See How to Rezero the Weighing Platform on page
160.
Is the Weighing Platform prop-
erly zeroed or tared?
See How to Fill the Automatic Label Dispenser on
page 76.
Are labels in place in the ALD?
(if you plan to print on tape)
To display the level of ink in the printing headset, see
How to Display Ink Level and Cartridge Data on page
194.
Is there enough ink in the cart-
ridge?
You can be warned when the available credit gets below a preset
value (see How to Set the Low-Credit Threshold on page 156).
38
| Page 38 | Jul-31-2018 12:32 |
3
Processing Mail
To Next Page
Loading...
Need help?
General
