page 2
This guide specifies how the Pro9 headset system should be installed and commissioned.
The LEDs on the base and headset use a sequence of colours, flashes and pulses to
indicate the status of the system and the item, which are explained in this guide.
CONTENTS
Preface page 3
Introduction page 3
What’s in the box page 3
Tools, cabling and equipment required page 3
System overview page 4
Installation procedure page 4
Appendix A Cat5 cable termination page 10
Appendix B Installing Pro9 system using existing cabling to page 11
connect the base station to the DTM located in
the order point (Q-P9NTEXT x1 Q-PNTINT x1)
Appendix C Installing Pro9 system using existing cabling to page 13
connect the base station to the DTM located in
the building (Q-P9JB x2)
Appendix D Pro9 auxiliary connections (Q-P9ACB) page 14
Appendix E Pro9 repeaters (Q-P9REP) page 15
Appendix F Pro9 table service (Q-P9BSTS) page 16
Appendix G Adjustments in system set up (connecting a page 17
computer to Pro9 base station)
Appendix H Connecting a computer to Pro9 base station page 18
using a wireless adaptor
Appendix I Setting up Pro9 as dual lane/tandem configuration page 20
(Q-P9BSDL)
Appendix J Recording a ‘Pull forward’ message page 23
Trouble shooting page 25
Manufacturer’s notes page 27
Regulatory notices page 28
Pro9 system components page 29
To Next Page
Loading...
