4
SAR Exposure
This device has been tested for compliance with FCC RF Exposure (SAR) limits
in typical flat configurations. In order to comply with SAR limits established in
the ANSI C95.1 standards, it is recommended when using a CF card that the
integrated antenna is positioned more than 1.5cm from your body or nearby
persons during extended periods of operation.
Declaration of Conformity
This device complies with Part 15 the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
European Notice
Products with the CE Marking comply with both the EMC Directive
(2004/108/EC) and the Low Voltage Directive (2006/95/EC) and R&TTE
Directive (1999/5/EC) issued by the Commission of the European Community.
Compliance with these directives implies conformity to the following European
Norms:
• EN55022: 2006, CLASS B
• EN61000-3-2: 2006, CLASS D
• EN61000-3-3: 1995+A1: 2001+A2: 2005
• EN55024: 1998+A1: 2001+A2: 2003
• IEC61000-4-2: 2001 ED. 1.2
• IEC61000-4-3: 2006 ED. 3.0
• IEC61000-4-4: 2004 ED. 2.0
• IEC61000-4-5: 2005 ED. 2.0
• IEC61000-4-6: 2006 ED. 2.2
• IEC61000-4-8: 2001 ED. 1.1
• IEC61000-4-11: 2004 ED. 2.0
• EN 300 328-2, EN 300 328-1, EN 301 489-1, EN 301 489-17
(ETSI 300 328, ETSI 301 489) Electro-magnetic Compatibility and Radio
Spectrum Matter.
To Next Page
Loading...
Need help?
General