錯誤
!
尚未定義樣式。
— Installing Hardware
11
Secure a 3.5” or 2.5” Hard Drive in the 3.5” Tray.
The 3.5” HDD tray can accommodate either a 3.5” HDD or a 2.5” HDD drive. Both options are depicted in the
following guide.
1. Secure the 3.5” hard drive to the tray with four (4) screws as shown. Do not over tighten the screws.
OR
Secure the 2.5” hard drive to the tray with three (3) screws as shown. Do not over tighten the screws.
The following images depict a 3.5” and 2.5” HDD in a 3.5” tray.
3.5” HDD in a 3.5” tray 2.5” HDD in a 3.5” tray
Note:
The 3.5” HDD tray can accommodate either a 3.5” HDD or a 2.5” HDD drive.
2. Replace the HDD tray and push firmly until the sits flush in the HDD bay.
3. Close the locking handle by pushing it in the direction shown until it clicks.
To Next Page
Loading...
