WARNING!
In a single CPU configuration, the single processor must be installed in the CPU_1
socket
(see QSSC-980 2U Mainboard Components on page 9 for location).
Refer to the following instructions to install CPUs:
1. Pull the locking lever of the CPU socket out and up as shown.
2. Push down as demonstrated to lift the CPU bracket.
3. Remove the CPU dust cover by lifting the tab marked Remove.
4. Locate the pin-1 corner of the CPU (marked by a small triangle) and the pin-1 corner of the socket; note
that the CPU has notches that fit into the socket.
To Next Page
Loading...
