錯誤
!
尚未定義樣式。
— Installing Hardware
26
Replacing the Riser Card
Refer to the following illustrations for instructions on replacing the riser card:
1. Remove the top cover. See Removing the Chassis Cover on page 12.
2. Firmly grasp the riser assembly and lift up and away. See the following image.
3. Turn the assembly over and place on a clean static mat.
4. Remove the securing screws, and pull out the riser card as shown in the following figure.
To replace the riser card, reverse steps 6 to 1.
To Next Page
Loading...
