Quantum DXi6900

Chapter 6: Replication
Replication Send
Quantum DXi6900 User’s Guide 144
Note:If a synchronization fails, make sure the target share or partition is unlocked (see Configuring a
Target Share for Directory/File Based Replication on page 154 or Configuring a Target Partition for
Cartridge Based Replication on page 164).
To synchronize a share or partition:
1. Select the share or partition to synchronize.
If multiple targets are configured, click the arrow next to the share or partition to display all targets, and
then select the desired target.
2. Click SynchronizeNow.
The status of the synchronization job displays in the JobStatus column.
To cancel the synchronization job, select the share or partition and click Abort.
Directory/File or Cartridge Based Replication Queue
The Directory/File or Cartridge Based Replication displays replication statistics for shares or partitions that
are configured for Directory/File or Cartridge Based Replication (see Configuring Directory/File or Cartridge
Based Replication on page 141).
To view the Directory/File or Cartridge Based Replication Queue:
1. Select a share or partition that is configured for Directory/File or Cartridge Based Replication.
If multiple targets are configured, click the arrow next to the share or partition to display all targets, and
then select the desired target.
2. Click Queue.
The Directory/File or Cartridge Based Replication Queue displays the following information for the
share or partition:
File/DirectoryorBarcode The file/directory or cartridge to be replicated.
State The replication state for the file/directory or cartridge.
Progress The percentage complete for replication of the file/directory or cartridge.
EstimatedDuration The estimated time it will take to complete replication for the file/directory
or cartridge.
Note:The estimated duration may display as unknown if replication
has been very recently initiated. After the system has enough
information to calculate a value, the estimated duration will display.
AdditionalInformation
l The contents of the Directory/File or Cartridge Based Replication Queue are dynamic. Because
of this, statistics are subject to change if items are added to the queue.