Quantum DXi6900

Chapter 9: Configuration
System
Quantum DXi6900 User’s Guide 351
FC Initiators and Targets
The FCInitiators&Targets page allows you to see all path to tape initiator and target ports and their
associated World Wide Port Numbers (WWPNs). You can also change a Fibre Channel port to initiator or
target mode.
To access the FCInitiators&Targetspage, on the System page, click the FCInitiators&Targets tab
(see Figure 224 below).
Figure224:FC Initiators and Targets Page
Tasks
Use the FCInitiators&Targets page to perform the following tasks:
View information about initiator and target Fibre Channel ports (see Fibre Channel Initiators and Targets
List below).
Change the mode of a Fibre Channel port (see Editing the Fibre Channel Port Type on the next page).
Fibre Channel Initiators and Targets List
The FibreChannelInitiators&Targets section displays the following information for all Fibre Channel
ports:
Alias The alias of the Fibre Channel port.
WWPN The World Wide Port Number of the Fibre Channel Port.
PortType The current mode of the Fibre Channel port (Initiator or Target).
Note:Click Refresh to update the list with the latest port information.
The BackpanelLocations section displays a graphical representation of the Fibre Channel ports as they
appear on the rear of the system. The diagram shows the status of each Fibre Channel port: Mapped
Target (green), UnmappedTarget (yellow), ActiveInitiator (blue), or InactiveInitiator (orange).