Quantum DXi6900

Chapter 9: Configuration
Scheduler
Quantum DXi6900 User’s Guide 282
EditanExistingEvent
l To edit an existing event, double-click the event. If the event is recurring, select Openthis
occurrence to edit only the one instance of the event, or select Opentheseries to edit the
entire recurring series, and then click OK.
l You cannot edit an event that occurred in the past.
l You can also right-click an existing event to see options for editing an event.
Figure175:Adding a New Event
2. Define the start and, if applicable, the end of the event.
l Specify the StartDateand StartTime using the pop-up calendar and drop-down box.
l (Replication throttle events only) Specify the EndDate and EndTime. The end date and time must
occur after the start date and time.
Note:For a new event, you can click and drag to adjust the start and end time. For an existing
event, you can drag the event to change when it occurs. You can also drag the left or right edge of
the event to adjust the start or end time.
3. Enter a brief description of the event in the Description box. (This description will display on the
schedule view.)
4. Specify options specific to the type of event. See the following sections:
l Scheduling a Share or Partition for Replication on the next page
l Scheduling Replication Throttling on page 284
l Scheduling E-mail Reports on page 285