Quantum DXi6900 - Page 81

Chapter 4: Configuration Wizards
NAS Wizard
Quantum DXi6900 User’s Guide 81
Enablededuplication (CIFS/SMB/NFS shares only) Select the check box to enable data
deduplication. Quantum recommends that you enable data
deduplication to optimize disk usage.
Note:Data deduplication is enabled by default. You cannot
enable or disable data deduplication after the share is added.
Note:Deduplication of Application Specific shares is enabled
by default.
Hidefromnetworkbrowsing (CIFS/SMB shares only) Select the check box to hide the share
from network browsing. If selected, you cannot see the share when
browsing the network.
2. Click Add.
3. (Optional) To add additional shares, repeat Steps 1–2.
4. Click Next to continue.
Figure44:NAS Wizard: Add Share
Step 4: Confirm
1. Review the settings you selected to make sure they are correct (see Figure 45 on the next page). If
necessary, click Previous to return to a previous step to make changes.
2. To make changes to a NAS share you added, first select the share and click Delete to delete the share.
Then click Previous to return to the previous step and add a new share.
3. After you have confirmed all settings, click Finish. The wizard configures the DXi6900 with the settings
you selected.