Quantum DXi6900

Chapter 4: Configuration Wizards
OST Wizard
Quantum DXi6900 User’s Guide 94
Step 3: Add LSUs
1. Enter information about the LSU (see Figure 55 on the next page).
LSUInformation Description
StorageServer Select the storage server that will contain the new LSU.
UseAvailableCapacity Select this option to add an LSU that uses the available capacity on the
system.
You cannot add an available capacity LSU to a storage server that
already contains an LSU. Also, if you add an available capacity LSU to a
storage server, you cannot add additional LSUs to that same storage
server.
Note:After you add an LSU that uses the AvailableCapacity
option, you cannot change the LSU to use the SpecificCapacity
option. Instead, you must delete the LSU, then add a new LSU and
choose the SpecificCapacity option (see Deleting an LSU on page
261).
SpecifyCapacity Select this option to specify the physical capacity of the LSU, and then
enter the following information.
l LSUName - Enter the name of the LSU.
l PhysicalCapacity - Enter the physical capacity of the LSU (1 to
1048576 GB).
2. Click Add.
The LSU displays in the LSUsAdded table.
3. (Optional) To add additional LSUs, repeat Steps 1–2.
To remove an LSU, select it in the LSUsAdded table and click Delete.
4. Click Next to continue.
Note:To configure the LSU for Automatic Image Replication, use the Configuration>OST>LSU
page (see LSU on page 255).