Quantum DXi6900

Chapter 4: Configuration Wizards
Replication Wizard
Quantum DXi6900 User’s Guide 99
Figure59:Replication Wizard: System
Step 3: NAS Share
1. Select a NAS share in the ReplicationSettingsforNASShares section to manage its replication
settings (see Figure 60 on page 101).
Note:For help adding NAS shares to the system, use the NAS Configuration Wizard (see NAS
Wizard).
2. To configure the share to replicate its data to another DXi system, enter the following information under
Send:
a. Select the Enablereplicationforselectedshare check box to enable replication for the share.
b. (Optional on CIFS/SMB and NFS shares only) Select the EnableDirectory/Filebased
replicationtotarget check box to enable Directory/File Based Replication for the share, and then
enter a SyncID in the box.
With Directory/File Based Replication, a file is automatically replicated when it is closed or a period
of time after it is modified. After replication, the replicated files are immediately available on the
target system.
Note:Application Specific (RMAN) shares have Directory/File Based Replication enabled by
default. When an RMAN share is selected, this check box does not appear.