Appendix A: Error Codes and Messages
QuantumLTO-7 HH SAS User’s Guide 95
6 For Problems with Reading Data:
If the problem occurred while the tape drive was reading data from the tape,
perform one
of the following procedures:
• If another tape drive is available, insert the cartridge into the other unit and retr
y the
operation:
• If the operation fails, discard the defective cartridge.
• If the operation succeeds, insert a scratch d
a
ta cartridge into the first unit and run
Function Code 1: Run Drive Diagnostics on page 48:
• If the diagnostic fails, replace the tape drive.
• If the diagnostic succeeds, the error was temporary.
• If another tape drive is not available, insert a scratch data cartridge into the unit and run
Function Code 1: Run Drive Diagnostics on page 48:
• If the diagnostic fails, replace the tape drive.
• If the diagnostic succeeds, discard the cartridge.
If the problem occurs with multiple tape cartridges, run
Function Code 1: Run Drive
Diagnostics on page 48:
• If the diagnostic fails, replace the tape drive.
• If the diagnostic succeeds, run
Function Code H: Test Head on page 60.
• If the diagnostic fails, replace the tape drive.
• If the diagnostic succeeds, replace the cartri
dges that caused the problem.
The error code clears when you remove the tape cartridge or place the tape
drive in
maintenance mode.
Error
Code Cause and Action
To Next Page
Loading...
Need help?
General
