EasyManuals Logo

Quantum LTO-8 HH SAS User Manual

Quantum LTO-8 HH SAS
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #102 background imageLoading...
Page #102 background image
Appendix A: Error Codes and Messages
94 QuantumLTO-7 HH SAS User’s Guide
6 Tape drive or media error. The tape drive determined that an error occurred, but it cannot
isolate the error to faulty hardware or to the tape cartridge. Ensure the tape cartridge is the
correct media type:
Ultrium 1, 2, 3, 4, 5 and 6 cartridges are not supported in the Ultrium 8 tape drive.
Drive will not accept an expired Cle
aning Cartridge.
Drive will not accept a WORM cartridge when running diagnostic tests in Maintenance
Mode.
Drive will not write over existing datasets on a WORM cartridge. Ensure
you are
appending datasets on WORM media rather than attempting to write over existing
datasets.
If the tape cartridge is the correct media type, perform the
following action:
6 For Problems with Writing Data:
If the problem occurred while the tape drive was writing data to the tape, retry the
ope
ration with a different cartridge:
If the operation succeeds, the original cartridge was defective. Copy data from the
defective cartridg
e and discard it.
If the operation fails and another tape drive is availabl
e, insert the cartridge into the other
unit and retry the operation.
If the operation fails, discard the defective cartridge.
If the operation succeeds, insert a scratch d
a
ta cartridge into the first unit and run
Function Code 1: Run Drive Diagnostics on page 48.
If the diagnostics fail, replace the tape drive.
If the diagnostics succeed, the error was temporary.
If the operation fails and another tape drive is not available, insert a scratch data cartridge
into the unit and run
Function Code 1: Run Drive Diagnostics on page 48.
If the diagnostics fail, replace the tape drive.
If the diagnostics succeed, discard the cartridge.
If the problem occurs with multiple tape cartridges, run
Function Code 1: Run Drive
Diagnostics on page 48:
If the diagnostics fail, replace the tape drive.
If the diagnostics succeed, run
Function Code H: Test Head on page 60.
– If the diagnostic fails, replace the tape
drive.
– If the diagnostic succeeds, replace the cartridges that caused the problem.
The error code clears when you remove the tape cartridge or place the tape
drive in
maintenance mode.
Error
Code
Cause and Action

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum LTO-8 HH SAS and is the answer not in the manual?

Quantum LTO-8 HH SAS Specifications

General IconGeneral
Native Capacity12TB
Compressed Capacity30TB
Native Data Transfer Rate300 MB/s
Buffer Size1GB
MTBF250, 000 hours
Media TypeLTO Ultrium 8
InterfaceSAS
Compressed Data Transfer Rate750 MB/s
EncryptionAES 256-bit
Backward CompatibilityLTO-7, LTO-6
CompatibilityLTO-8

Related product manuals