EasyManuals Logo

Quantum LTO-8 HH SAS User Manual

Quantum LTO-8 HH SAS
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #101 background imageLoading...
Page #101 background image
Appendix A: Error Codes and Messages
QuantumLTO-7 HH SAS User’s Guide 93
3 Firmware problem. The tape drive determined that a firmware error occurred. Perform the
following action:
1 Collect a drive dump from one of the following:
Note: Do not force a new dump; the tape drive ha
s already created one.
Server's host interface by using a device driver ut
ility or system tool
•Ultrium Tape Drive (to copy and read a dri
ve dump, use Function Code 5: Copy Drive
Dump on page 52), visit http://www.quantum.com/serviceandsupport
2 Power the tape drive off and on, then retry the operation that produced the error.
3 If the problem persists, download new firmware and retry the operation.
4 If the problem
persists, send the drive dump that you collected in step 1 to your Quantum
Support Center.
The error code clears when you place the tape drive in maintenance mode.
4 Firmware or hardware problem. The tape drive determined that
a firmware or tape drive
hardware failure occurred. Perform the following action:
1 Collect a drive dump from one of the following:
Note: Do not force a new dump; one already exists.
Server's host interface by using a device driver utility or syste
m tool (for instructions about
reading a drive dump from tape, visit the Web at
http://www.quantum.com/
serviceandsupport)
Ultrium Tape Drive (to copy and read a drive dump, use Function Code 5: Copy Drive
Dump on page 52)
2 Power the tape drive off and on, then retry the
operation that produced the error. The
error code clears when you place the tape drive in maintenance mode.
3 If the problem persists, download new firmware and retry
the operation; if new firmware
is not available, replace the drive.
5 Tape drive hardware problem. The drive determined that a
tape path or read/write error
occurred. To prevent damage to the drive or tape, the tape drive will not allow you to insert
a cartridge if the current cartridge was successfully ejected. The error code may clear when
you cycle power to the tape drive or place it in maintenance mode. If the problem persists,
replace the drive.
Note: Copy the drive dump to flash memory before retur
n
ing the drive. For instructions,
refer to
Function Code 5: Copy Drive Dump on page 52.
Error
Code Cause and Action

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum LTO-8 HH SAS and is the answer not in the manual?

Quantum LTO-8 HH SAS Specifications

General IconGeneral
Native Capacity12TB
Compressed Capacity30TB
Native Data Transfer Rate300 MB/s
Buffer Size1GB
MTBF250, 000 hours
Media TypeLTO Ultrium 8
InterfaceSAS
Compressed Data Transfer Rate750 MB/s
EncryptionAES 256-bit
Backward CompatibilityLTO-7, LTO-6
CompatibilityLTO-8

Related product manuals