Quectel EM06 Series - Page 14

LTE-A Module Series
EM06 Series Hardware Design
EM06_Series_Hardware_Design 13 / 69
Transmitting Power
⚫ Class 3 (23 dBm ±2 dB) for LTE-FDD bands
⚫ Class 3 (23 dBm ±2 dB) for LTE-TDD bands
⚫ Class 3 (24 dBm +1/-3 dB) for WCDMA
LTE Features
⚫ Up to LTE Cat 6
⚫ 1.4 MHz to 40 MHz (2 × CA) RF bandwidth
⚫ MIMO in DL direction
⚫ LTE-FDD:
- DL: Max. 300 Mbps
- UL: Max. 50 Mbps
⚫ LTE-TDD:
- DL: Max. 226 Mbps
- UL: Max. 28 Mbps
UMTS Features
⚫ 3GPP R8 DC-HSDPA, HSPA+, HSDPA, HSUPA and WCDMA
⚫ QPSK, 16QAM and 64QAM modulation
⚫ DC-HSDPA: Max. 42 Mbps (DL)
⚫ HSUPA: Max. 5.76 Mbps (UL)
⚫ WCDMA: Max. 384 kbps (DL/ UL)
Internet Protocol Features
⚫ PPP/QMI/NTP*/TCP*/UDP*/FTP*/HTTP*/PING*/HTTPS*/SMTP*/
MMS*/FTPS*/SMTPS*/SSL* protocols
⚫ Support PAP and CHAP protocols, which are usually used for PPP
connection
SMS
⚫ Text and PDU modes
⚫ Point to point MO and MT
⚫ SMS cell broadcast
⚫ SMS storage: ME by default
(U)SIM Interfaces
⚫ Support (U)SIM card: 1.8 V, 3.0 V
⚫ Include USIM1 and USIM2 interfaces
⚫ Dual SIM Single Standby
Audio Feature
⚫ One digital audio interface: PCM interface
⚫ WCDMA: AMR/AMR-WB
⚫ LTE: AMR/AMR-WB
⚫ Echo cancellation and noise suppression
PCM Interface
⚫ Used for audio function with external codec
⚫ Support 16-bit linear data format
⚫ Support long frame synchronization and short frame synchronization
⚫ Support master and slave modes, but must be the master in long
frame synchronization
USB Interface
⚫ Compliant with USB 2.0 specifications, with maximum transmission
rate up to 480 Mbps on USB 2.0.
⚫ Used for AT command communication, data transmission, firmware
upgrade, software debug, GNSS NMEA sentences output and voice
over USB*
⚫ Support USB serial drivers for: