Quectel SG560D Series - RF Specifications; Cellular Network; Antenna Interfaces & Frequency Bands

Smart Module Series
SG560D_Series_Hardware_Design 90 / 134
5 RF Specifications
Appropriate antenna type and design should be used with matched antenna parameters according to
specific application. It is required to perform a comprehensive functional test for the RF design before
mass production of terminal products. The entire content of this chapter is provided for illustration only.
Analysis, evaluation and determination are still necessary when designing target products.
5.1. Cellular Network
5.1.1. Antenna Interfaces & Frequency Bands
The pin definition is shown below:
Table 36: Pin Definition of Cellular Network Interfaces of SG560D-CN
Table 37: Pin Definition of Cellular Network Interfaces of SG560D-EU
Pin Name
Pin No.
I/O
Description
ANT0
211
AIO
5G NR (n1/n3/n5/n8/n28 TRX, n41/n78/n79 TRX1) &
LTE LMHB TRX, WCDMA B1/B5/B8 TRX
ANT1
244
AI
5G NR (n1/n41/n78/n79 DRX MIMO) & LTE (B1/B41
DRX MIMO)
ANT2
256
AI
5G NR (n1/n3/n5/n8/n28/n41/n78/n79 DRX) & LTE
(LB/MB/HB DRX), WCDMA B1/B5/B8 DRX
ANT3
292
AIO
5G NR (n1 PRX MIMO, n41/n78/n79 TRX0) & LTE
(B1/B41PRX MIMO)
Pin Name
Pin No.
I/O
Description
ANT0
211
AIO
NR LMHB TRX0 + n77/n78 TRX0
LTE LMHB TRX0 + B42 TRX0
WCDMA B1/B5/B8 TRX
GSM900/DCS1800 TRX