UMTS/HSPA/LTE Module Series
UMTS<E EVB User Guide
UMTS<E_EVB_User_Guide Confidential / Released 12 / 44
Power key (push button)
Used to turn on/off the UMTS<E module
Jumper is used to connect PWRKEY to GND
Used to turn off the UMTS<E module
2)
Reset button (push button). It is used to reset the UMTS<E
module
Switched to the left: connect FC20's BT interface (UART,
PCM) to EC2x modules, for testing the BT function of FC20.
Switched to the right: connect the main UART and codec
board interfaces on EVB to UMTS<E module, for testing
the module's main UART functions, and the codec„s PCM
function.
Used for loud speaker
Used to test the analog audio function of UMTS<E module
Used for earphone
Used to test the analog audio function of UMTS<E module
Used for handset
Used to test the analog audio function of UMTS<E module
D209, D205,
D207, D208, D206
D209 is VBAT ON/OFF indicator.
D205 is used for indicating whether the UMTS<E module is
powered on.
D207 is used for indicating whether UMTS<E module is in
sleep mode.
D208 and D206 are used for indicating the network status of
UMTS<E module.
Connectors of UMTS<E TE-A
Wi-Fi & Ethernet
TE-A Interface
Connectors of Wi-Fi & Ethernet TE-A
Jumper used for VBAT voltage test
To Next Page
Loading...
Need help?
General
