If the can is full but the display shows the “no
water” symbol, carry out the water sensor
calibration procedure as described in the
paragraph “User menu /Maintenance”.
No water in can
If the level of the water in the can drops below the minimum level, the machine
generates an alarm and the following signal is shown on the display.
To exit from the alarm condition, fill the can.
When the machine is in alarm condition due to lack of water in the can, the boiler
continues to heat and it is possible to top-up the water level. It is also possible to
top-up when the heating is interrupted because there is no water in the boiler
Coffee dosing when there is no water in the can
If the water is missing in the can during the distribution of the coffee, the machine
generates an alarm only after the distribution.
To Next Page
Loading...
