Connection to water network
1. Connect the network water pipe to the coupling underneath the machine (u).
2. Position the can/network tap (q) on “network”.
For this machine model it is necessary that the water is collected
in the drips collection reservoir and is conveyed to the domestic
drainage.
For this reason it is necessary to connect the direst discharge
reservoir located under the machine (r) with the discharge pipe
(accessory “i”) supplied.
3. Switch on the machine through the main switch on the front of the machine,
above the display (h).
4. Using the Wi-Fi of a device, connect to the machine and on the relevant page
select ”water supply from network”, if it has not already been selected (for
the Wi-Fi connection and modification of the parameters, see the relevant
paragraph).
For the first use, with the machine warmed, run approx. 0.5 litres of water to flush
the coffee distribution group and the hydraulic circuit.
To Next Page
Loading...
