Q-41-MSII-2-EN 02-02-21
Technical updatings reserved!
Contents Page
Part 2
7. Description of the MINI-STOP Drive System 7.1 - 7.6
7.1 Motor QE 3760
7.2 Control system
7.3 Speed control unit SWG2
7.4 External operator panel OC-TOP
7.4.1 External operator panel OC-TOP/AQ
7.4.2 External operator panel OC-TOP/FQ
7.5 Drive System Application
8. Application 8.1 - 8.12
8.1 Sewing without an external operator's control panel
8.2 Sewing with external operator's control panel OC-TOP
8.2.1 Sewing without sewing program (manual sewing)
8.2.2 Sewing with sewing program (programmed sewing)
8.2.3 Sewing programs
8.2.4 Backtack / Darning programs
8.3 Error messages (Malfunction Diagnostics)
9. Programming by the user 9.1 - 9.14
9.1 User programming with operator panel OC-TOP
9.1.1 Direct programming
9.1.2 Parameter programming
9.1.2.1 Programming level A (operator level)
9.1.2.2 Programming level B (technician level)
9.1.2.3 Programming level C (special level)
9.1.3 Reset
9.2 User programming via the Internal Mini Programming Panel (MPF)
9.2.1 Indication 1: Backtack Stitches
9.2.2 Indication 2: Speed
9.2.3 Indication 3: Sewing functions
9.2.4 Indication 4: Control Paramerters
9.2.5 Reset
10. Start of operation 10.1 - 10.4
10.1 Control of the direction of rotation and of the reference position
from the needle bar (needle position NPO)
10.2 Control of the needle positions NP1 / NP2 / NP3 / NP9
10.3 Control of the needle positions for thread trimming (Parameters 704, 705, 706)
10.4 Control of the maximum speed
10.5 Hardware test
To Next Page
Loading...