Response:
In the righthand half of the display appears the first parameter of programming level C.
Calling up further parameter numbers and correcting the parameter values can be made in the same way
as described for programming levels A and B.
b) Deactivation of Programming Level C
- Deactivate key T10 (T/E) (going dark)
- Turn mains power switch OFF
9.1.3 Reset
a) Reset of Parameter Values
All parameter values having been modified from the ex-factory condition (standard value) are reset to
their standard values by this procedure.
Exceptions: parameters 700, 799 and 800
For these parameters, the values programmed by the user are retained even after
-Reset- has been performed.
-Reset- procedure:
- turn mains power switch OFF
- press treadle fully forward and hold in that position
- press and hold keys P- or P+, S- or S+ and L- or L+ simultaneously
- turn mains power switch ON
- release the three keys and the treadle
Q-41-MSII-2-EN 9.6 02-02-21
To Next Page
Loading...