Quick TCD 2022 - Page 22

22
TCD 2022 / 2042
EN
INSTALLATION AND USE MANUAL - REV 002A
3.4 - Enabling the control
To enable the control, press the enabling button and keep it pressed for at least 1 second.
After this interval the enabling LEDs will start flashing with greater frequency and the control will emit a short sound.
Release the enabling button, the enabling LEDs will remain steadily lit on and the control will be enabled.
In this condition the control will emit a short sound every 5 seconds.
3.5 - Bow thruster operation
3.6 - Stern thruster operation
ATTENTION : once the direction button (TCD 2022) or the joystick (TCD 2042) has been released, the boat will
continue to move due to inertia.
When the thruster is activated the direction LED corresponding to the commanded movement (red to the left, green to
the right) will light on and the control will emit an intermittent sound.
RIGHT DIRECTION
BUTTON
LEVER TO THE RIGHT
LEVER TO THE LEFTLEFT DIRECTION
BUTTON
RIGHT DIRECTION
BUTTON
LEVER TO THE RIGHT
LEVER TO THE LEFTLEFT DIRECTION
BUTTON
BOW TCD 2022 TCD 2042
STERN TCD 2022 TCD 2042
3.0 - OPERATION