Quickie Attitude Directions For Use

ENGLISH
12
Attitude/Attitude Hybrid Rev.1.0
WARNING!
• Always make sure that the device is switched off
before docking and dedocking.
• Ensure the wheelchair is fully connected with the add-
on bike before use, by using the handgrip A.
• As with all moving parts, there is a risk that fingers and
/ or clothing could become trapped. Please always
handle carefully.
Refere to the docking check list below:
Docking Pins
Fully locked In
√
Docking Levers
Fully Locked In
√
CAUTION!
• Always keep the docking system clean.
• Clean it after every trip paying particular attention to
sand and mud.
Docking: Fig.5.1 - Fig.5.5
• Drive your wheelchair as close as possible to the add-
on bike.
• The 2 docking pins on your wheelchair should stay
directly in front of the lower docking connector.
• The add-on bike should stand on an even surface.
• Lock the brakes of your wheelchair.
• Pull it towards you by using the handgrip, until the 2
docking pins lock into A.
• Now push the add-on bike upwards/forwards until the
stand wheels and the castors leave the ground B.
• Swing the upper docking connector downwards until it
stops, C.
• Lower the add-on bike until the upper docking
connector is in contact with the front frame of your
wheelchair.
• Pull the red locking lever backwards until it locks firmly
and completely, D.
• Clamping must be on the metal tube without any parts,
(e.g. calf strap, frame protectors), in between.
• Ensure the wheelchair is fully connected with the add-
on bike.
Fig.5.5
D
Fig.5.2
Fig.5.3
Fig.5.4
C
Fig.5.1
A
B
5.0 Docking and Dedocking

Quickie Attitude Specifications

General

Brand	Quickie
Model	Attitude
Category	Bicycle
Language	English