Operation
LF-100 User Guide 17
Run the Cut Test and Start a Job
Run the Black-Mark Mode
1. Open Virgo Cutting Manager.
2. Press “OPEN PDF” or “OPEN LAST JOB” to load the Cut File.
3. Look at the camera preview. Hold down “BACKWARD MEDIA” or “FORWARD MEDIA”
arrows to move the web until the black-mark goes in the center position of the blue
rectangle area.
4. Measure the distance in (MM) between the top of one black-mark to top of the next
black-mark. Key in this value in the “DISTANCE BETWEEN BLACKMARKS” box section.
5. Make sure “Enable” in the blank mode is unflagged.
6. Press “CUT TEST” to check for cut depth. If the liner has been cut, decrease the cutter
pressure value in the cut force box. If label doesn’t detach, increase the cutter pressure
value in the cut force box.
7. Make sure label is aligned with the cut. Through X and Y values in the software, adjust
offsets if cut doesn’t match label.
8. Once the cut settings are properly set, select “COPY MODE” ON if you desire a preset
quantity of copies or OFF to cut until the media roll is empty.
9. Set the black-mark size” in “BLACK-MARK MODE” area.
10. Press “START”.
Note: When you lower and raise the lever while you are in black-mark mode, hold down the
forward media arrow button to move the plotter’s head down again.
Run the Blank Mode
1. Press “OPEN PDF” or “OPEN LAST JOB” to load the cut file.
2. Set the copy mode ON, and set 2 as number of copies.
3. Click “START”.
4. Check the horizontal position and the gap between the cuts.
To Next Page
Loading...