QuickLabel LF-100 - Load the Matrix Remover Core Holder; Load the Rewinder Core Holder and Set the Slitter Module

Operation
LF-100 User Guide 18
5. If necessary, adjust the offset X and the distance between each cut in the “STEP” box.
6. Once the cut is set properly, select copy mode: ON if you desire a preset quantity of
copies, or OFF to cut until the media roll is empty.
7. Click “START”.
Load the Matrix Remover Core Holder
Warning: Before starting a job, always remove the waste media from the matrix remover core.
Tape the matrix securely onto the cardboard core. System operating issues may occur if these
suggestions are not followed.
1. Load empty cardboard core(s) and tighten the core holder, then place the motorized core
holder in position.
2. Peel back the matrix.
3. Pull the matrix and attach it to the matrix remover core holder.
4. Pull down the waste press and relocate the o-rings to be over the waste matrix.
5. Close the sponge roller.
Load the Rewinder Core Holder and Set the Slitter Module
1. Load empty cardboard core(s) and tighten the core holder, then place the motorized core
holder in position.
Cardboard core(s) should not be wider than the width of the finished roll