Maintenance
LF-100 User Guide 32
Mounting the Tool
1. Loosen the tool holder screw.
2. While pushing up the tool holder, push until its flange completely touches the upper part
of the holder.
When using with half cutting and plotter pen, set the seal in Tool Holder 1 (backward),
and when using cutting out (perforated cut), set the seal in Tool Holder 2 (forward).
3. Make sure that the tool bracket is engaged on the tool’s flange, and then tighten the
screw.
Removing the Tool
When removing the tool, turn it counterclockwise to remove the tool.
To Next Page
Loading...