3. Solenoid Valves
Rada SV1015 (HP) Solenoid Valve (Direct Acting)
A 1/2" servo assisted solenoid valve, made from WRC approved PA66 Reinforced
Fibreglass, tted with 15 mm compression connections. Flat-faced inserts are
supplied for 1/2" BSP union inlet or outlet connections. An isolating ball valve is
tted to the inlet to allow the water supply to be isolated. A ow direction arrow on
the valve facilitates correct installation.
Rada SV2022 Solenoid Valve (Indirect Acting)
A 3/4" servo assisted solenoid valve made from brass with 3/4" BSP female
connections. A ow direction arrow on the valve facilitates correct installation.
Rada SV2028 Solenoid Valve (Indirect Acting)
A 1" servo assisted solenoid valve made from brass with 1" BSP female connections.
The valve is marked "IN" on the end to connect the inlet water supply.
Rada SV3022 Solenoid Valve (Direct Acting)
A 3/4" lift assisted solenoid valve made from brass with 3/4" BSP female
connections.
A ow direction arrow on the valve facilitates correct installation.
To Next Page
Loading...
Need help?
General
