Need help? Call
1-888-284-8735
49
Note:
If you are searching for a VCR, CD
player, laser disc player, or DVD player code,
insert a tape or disc and press
PLAY
instead of
POWER
.
5. Press
P
within 10 seconds to save the code.
Notes:
• If you do not press
P
within 10 seconds, the
remote control does not save the code. You
must start again from Step 1.
• Because the 6-in-One’s library has so many
codes, this procedure can take several minutes.
• If your device turns off during the search, but
does not operate after you lock in the code,
begin the search again, pausing longer between
key presses.
Determining the 4-Digit Code
After you have set up your devices using the Code
Search feature, you might need to find out which
code is operating one of them. For example, to find
out what 4-digit code is operating your TV:
1. Turn on the TV and press
TV
.
2. Hold down
P
until the red light blinks twice.
3. Press
9 9 0
. The red light blinks twice again.
4. Press
1
, then count the number of times the red
light blinks and write it down. This is the first
digit of the 4-digit code.
Note:
If the red light does not blink, the digit is
0
.
5. Repeat Step 4, pressing
2
,
3
, and
4
, to see each
additional digit.
15-1994.fm Page 49 Tuesday, February 29, 2000 2:04 PM
To Next Page
Loading...
Need help?
General
