Need help? Call
1-888-284-8735
10
OPERATION
1. Press the device key for the device you want to
control.
2. Point the remote control toward the device you
want to control, then press the desired com-
mand keys.
3. Repeat Steps 1 and 2 for all other devices you
want to operate.
Note:
The command keys on the remote con-
trol work the same as the keys on the original
remote control; however, the labeling might dif-
fer slightly.
4. To turn off the last device you selected, press
POWER
. To turn off other devices, press the
device key for the device you want to turn off,
then press
POWER
.
USING THE LIGHT
The backlight lets you see the keys on your 6-in-One
in the dark. Press to turn on the light. The keypad
lights for about 5 seconds. Then, every time you
press a key, the 6-in-One lights up and stays lit for
about 5 seconds. To turn off the light, press
again.
CONVERTING DEVICE KEYS
You can use your 6-in-One Remote to operate a sec-
ond TV or VCR (or other components) for a total of
up to six devices. To do this, you must first convert
an unused device key (
AUX1
,
AUX2
,
VCR
,
TV
,
CD
,
CBL/SAT
) to operate each additional device. For ex-
ample, to convert
AUX1
to operate a second
TV
:
1. Hold down
P
until the red light blinks twice.
15-1994.fm Page 10 Tuesday, February 29, 2000 2:04 PM
To Next Page
Loading...
Need help?
General
