Need help? Call
1-888-284-8735
9
3. Press
VCR
then hold down
P
until the red light
blinks twice.
4. Enter the 4-digit code.
For example, to replace a Panasonic TV/VCR
combination’s remote control (set-up code
1162), press
VCR
, hold down
P
until the red light
blinks twice, then press
1 1 6 2
.
When the red light blinks twice, the remote con-
trol has accepted the code.
Note:
If the code you entered is invalid, the red
light makes one long blink.
5. Point the 6-in-One at your TV/VCR combination
and press
POWER
or
PLAY
. Your TV/VCR com-
bination should turn off or start to play.
If the remote does not operate your TV/VCR combi-
nation, try the other codes you wrote down in Step 1.
Note:
Some TV/VCR combinations require a second
code to control volume. If you cannot control the vol-
ume, use the TV code listed in “TV/VCR Combina-
tions” on Page 37.
15-1994.fm Page 9 Tuesday, February 29, 2000 2:04 PM
To Next Page
Loading...
