58
Beyond the Basics
turning channel-storage banks off and on
To turn off banks while scanning, press the bank’s
number key so the bank’s number disappears. For
example, to turn off bank 1, press
1. The scanner does
not scan any of the channels within the banks you
turned off.
To turn on banks while scanning, press the number key
until the bank’s number appears. For example to turn
bank 1 on again, press 1.
You cannot turn off all banks. There must be at
least one active bank.
You can manually select any channel in a bank,
even if the bank is turned off.
monitoring a single channel/power save circuit
You can monitor a single channel with your scanner by
navigating to that channel while in manual mode. The
scanner will receive traffi c on the selected frequency.
To Next Page
Loading...
