72
Beyond the Basics
order. For example, home repeater order 1 would
go into channel 01 for the current bank, and home
repeater order 2 would go into channel 02.
Follow these steps to program trunked frequencies:
1. Press PROG and select the bank.
To move through the bank selection faster, press
PROG then FUNC and hold down e or d. To move
through the banks one at a time, repeat the
sequence of PROG, FUNC then e or d until you reach
the desired bank.
2. Press TRUNK to enter the ID program mode.
3. Repeatedly press MODE to select Motorola, EDACS
(GE/Ericsson), or LTR (EF Johnson) system to scan.
This sets the talk group ID decoding method to be
used for the bank.
If you select conventional mode instead of
Motorola, EDACS, or LTR, the scanner does not
scan trunked frequencies. Trunking mode not
selected, press Mode key. appears.
To Next Page
Loading...
