75
Beyond the Basics
4. Press FUNC then 2. The display indicates Custom Range
1/3 on fi rst line, Base: 406.0000 on the second line,
Offset: 380 on the third line and Step:25.0kHz on the
bottom line.
5. While B in Base blinks, if necessary, press the
desired Base frequency with the number keys and
press ENT. Confi rm the entry. If it is incorrect, press
the number keys again to set the base frequency.
After you confi rm the input, press ENT again.
6. While O in Offset blinks, if necessary, enter the offset
number and press ENT. Confi rm the entry. If it is
incorrect, then press the number keys again to set
the frequency. After you confi rm the input, press
ENT again.
7. While S in Step blinks, repeatedly press e or d to
select the step number, 5.0, 6.25, 10.0, 12.5, 15.0,
18.75, 20.0, 25.0, 30.0, 31.25, 35.0, 37.5, 40.0,
43.75, or 50.0 kHz, then press ENT.
8. Press PROG to enter the program mode. Store the
trunking IDs into the sub-bank in the same bank.
programming Motorola trunking systems (800
MHz)
Follow these steps to program 800 MHz band Motorola
trunking.
On the 800 MHz trunking band, you can select a
base frequency (normal or offset).
On the 900 MHz trunking band, you do not need to
set the base frequency (base, offset, step).
1. Press PROG then TRUNK to enter the ID program
mode.
To Next Page
Loading...
