13
1. Connect the DC adapter’s orange barrel plug to the
adapter’s cable, with the tip set to – (negative).
2. Set the adapter’s voltage switch to 9V.
3. Insert the barrel plug into the scanner’s
PWR/DC 9V
jack.
4. Plug the other end of the adapter into your vehicle’s
cigarette-lighter socket.
Note:
If the scanner does not operate properly when you
connect a DC adapter, unplug the adapter from the ciga-
rette-lighter socket and clean the socket to remove ashes
and other debris.
Charging a Rechargeable Battery Pack
Your scanner has a built-in charging circuit that lets you
charge a rechargeable scanner battery pack (Cat. No. 23-
288, not supplied) while it is in the scanner. To charge a
battery pack, simply connect an appropriate AC or DC
adapter to the
PWR/DC 9V
jack.
Note:
If you want to take the battery pack out of the scan-
ner to charge it, follow the instructions provided with the
battery pack.
It takes about 14-16 hours to recharge a battery pack that
is fully discharged. You can operate the scanner while re-
charging the battery pack, but the charging time is length-
ened.
1
2
3
4
20-310.fm Page 13 Wednesday, August 4, 1999 10:49 AM
To Next Page
Loading...
