25
Using Band Search
If you do not know of a frequency to store, you can search
your scanner’s preprogrammed search bands for active
frequencies, then store any that you find into your scan-
ner’s channels.
Follow these steps to search for and store active frequen-
cies using band search.
1. Press
BAND
. The last selected band number (
b
fol-
lowed by a number, such as
b2
) and the associated
frequency search range appear on the display.
2. To select a different band, within 2 seconds, enter
the desired band number (
0
-
9
, see Page 4 for
descriptions) or repeatedly press
BAND
until the
desired band number appears on the display. After
about 2 seconds,
SRCH
appears, the next avail-
able channel flashes, and the scanner begins
searching rapidly upward in that band (from lowest to
highest frequency) for an active frequency.
Notes:
• To select a different band after the scanner begins
searching the current band, simply repeat this
step.
20-310.fm Page 25 Wednesday, August 4, 1999 10:49 AM
To Next Page
Loading...
