11
When you finish using the DC cigarette-lighter power ca-
ble, disconnect it from the cigarette-lighter socket, then
disconnect it from your scanner.
Note: If the scanner does not operate properly when you
connect a DC cigarette-lighter power cable, unplug the
power cable from the cigarette-lighter socket and clean
the socket to remove ashes and other debris.
CONNECTING THE ANTENNA
Follow these steps to attach the supplied flexible anten-
na to the connector on the top of your scanner.
1. Align the slots around the antenna’s connector with
the tabs on the scanner’s BNC connector.
2. Slide the antenna’s connector down over the scan-
ner’s connector and rotate the antenna connector’s
outer ring clockwise until it locks into place.
20-520.fm Page 11 Wednesday, August 4, 1999 3:06 PM
To Next Page
Loading...
