25
SCANNING THE STORED CHANNELS
To begin scanning channels, press
SCAN
. The scanner
scans through all non-locked channels in the activated
banks. When the scanner finds a transmission, it stops
on it. When the transmission ends, the scanner resumes
scanning.
Note:
To scan in the trunk tracking mode, see “Scanning
a Trunked Bank” on Page 36.
MANUALLY SELECTING A CHANNEL
You can continuously monitor a single channel without
scanning. This is useful if you hear an emergency broad-
cast on a channel and do not want to miss any details —
even though there might be periods of silence — or if
you want to monitor a specific channel.
Follow these steps to manually select a channel.
1. Press
MANUAL
.
2. Enter the channel number.
3. Press
MANUAL
again.
Or, if your scanner is scanning and stops at the desired
channel, press
MANUAL
one time. (Pressing
MANUAL
ad-
ditional times causes your scanner to step through the
channels.)
To resume scanning, press
SCAN
.
DELETING A STORED FREQUENCY
1. Press
MANUAL
.
2. Use the number keys to enter the channel number
containing the frequency you want to delete. Then
press
MANUAL
again.
3. Press
0
, then press
E
. The frequency is deleted.
Note:
Channels with no frequencies are automatically
locked out during scanning.
20-520.fm Page 25 Wednesday, August 4, 1999 3:06 PM
To Next Page
Loading...
