2.22 Subsidiary ID “ID SEED”
ID SEED function means designating a subsidiary ID among multiple binding receivers to realize the control.
There are totally 10 independent subsidiary IDs can be stored.
For example, RC6GS V2 V2 has completed the binding with 10 different boats and the setup of respective
parameters. Turn on the ID SEED function, select ID.1 boat and drive it to the central of water but it stops
working unexpectedly. Then we can change to the ID.2 boat (or any other subsidiary ID boat preferred) and
control it independently to rescue ID. 1 boat instead of controlling both boats at the same time, which makes
the rescue more difficult. Unlike traditional binding mode, independent ID can easily realize rescuing stalled
boat in the water caused by various reasons.
Press EXIT and ENTER simultaneously to enter MENU=>press Inc(+)/DEC（-） to highlight “22. ID
SEED=>Press ENTER => Change the MODE from OFF to ON=> set the subsidiary ID number=> complete
biding and parameters setting.
Once finished , the corresponding ID number will be displayed on the RC6GS V2 main interface .
2.23 Factory Reset “RESET”
RESET- Data reset function:
All the data for any model memory can be reset to original factory
defaults. Often this function is done to get a “fresh start” and clear the
memory before inputting new model settings.
(1) Enter the function menu and use “Dec(-)” or “Inc(+)” button to
access RESET function.
(2) Press “Enter” button to get into RESET function interface, the
symbol “YES” will blink.
Be sure to reset
Press “Enter” key, the symbol “YES” will stop blinking, and return to the
initial screen. Now the model data is reset to the initial setting that is the default value set at the factory.
Not to reset
Press “Dec(-)” or “Inc(+)” button, the symbol “YES” will stop blinking and the symbol “NO” will blink, press
“Enter” key, the symbol “NO” will stop blinking, return to the initial screen by pressing “Exit” button twice.
Or you can press “Exit” button twice to quit resetting directly.
CAUTION: Resetting the current model memory will permanently erase ALL programming information for that
model. The data cannot be recovered. Do not reset the model unless you are certain you want to clear-out
that memory and start from scratch.
Thank you again for choosing our product。
To Previous Page
Loading...
Need help?
General
