RadioLink RC6GS V2 - Receiver Gyro Setup

RadioLink Electronic Ltd
www.radiolink.com
4
R7FG Working Mode
Working Mode
Mode 1
Mode 2
Mode 3
Mode 4
Note
Indicator Color
Green
Blue
Red&Blue
(Purple)
Red&Green
(Orange)
/
With Gyro
N
N
Y
Y
Multicolor light indicator on
means gyro function on
Channel
Corresponding signal output in different channel
/
BAT+-
Return port of model battery voltage
/
1
PWM
PWM
PWM
PWM
Rudder
2
PWM
PWM
PWM
PWM
Throttle
3
PWM
PWM
PWM
PWM
Aux
4
PWM
PWM
PWM
PWM
Aux
5
PWM
PWM
PWM
PWM
Aux
6
PWM
PWM
PWM
PWM
Aux
PPM/S.B
PPM
SBUS
SBUS
PPM
Green is PPM, Blue is
S-BUS
，
flight controller can be
connected under SBUS/PPM
mode and achieve different
models control incl.
Mecanum
car/Robot/Engineering
Off-road cars
Signal Switch
Short press
ID set once
to Mode 2
Short press
ID set once
to Mode 1
Short press ID
set once to
Mode 4
Short press ID
set once to
Mode 3
/
Short press
ID set 3
times
quickly to
Mode 4
Short press
ID set 3
times
quickly to
Mode 3
Short press ID
set 3 times
quickly to
Mode 2
Short press ID
set 3 times
quickly to Mode
1
/
1.2.3 Gyro Setup
A. Gyro Enabled
Factory setting is gyro function OFF by default.
Short press ID SET three times with interval less than 1 second, the RED indicator flashes three times. Red
LED on/off indicates the gyro function is on/off.
B. Gyro Phase
When the gyro forward is enabled, try to turn the model car to check if the gyro is correcting the wheels.
Normally, the wheels should turn right to correct when the car is turned left while the wheels should turn left to
correct when the car is turned right. If the gyro phase is reversed, short press the binding button (ID SET)
twice in 1 second. The Red indicator flashes twice means the gyro phase setting is complete.