RadioLink RC8X - Transmitter Low Voltage Alarm; R8 FG Introduction; Binding

RadioLink Electronic Limited
www.radiolink.com
10
Transmitter Low Voltage Alarm
Transmitter low voltage alarm is 6.8V by default. If the voltage of
transmitter battery is lower than 6.8V, the transmitter will alarm with
sound "transmitter voltage low", please change the battery when
you heard the alarm, the transmitter low voltage alarm can be set
in the battery menu according to your battery that powered for your
RC8X.
Normally we set the alarm value with the single cell voltage as 3.7V.
If you use a 2S LiPo battery to power for your RC8X, you can set
the alarm to 7.4V for 2S LiPo battery (3.7V*2=7.4V), 11.1V for 3S
LiPo battery , and 14.8V for 4S LiPo battery.
Setting steps: turn on your RC8X, enter into System menu - Battery, and then adjust the alarm
voltage.
RC8X is packed with an 8-channel receiver R8FG, splash-proof, gyro integrated, and high
voltage servo supported. The gyro function of R8FG is turned off (Green LED) by default. Check
the follow gyro function introduction for methods on how to turn on the gyro.
Binding
RC8X and R8FG have finished binding by default. Turn on the RC8X and the R8FG, the signal
tower will show on the top of the screen as in the picture below, it means the transmitter and
receiver have finished binding.
Please make sure there is successful binding between the
transmitter and receiver. Each receiver has an individual ID
code. When the binding is done, the ID code will be stored in
the transmitter and there's no need to rebind.
Binding steps:
① Put the transmitter and the receiver close to each other (about 60 centimeters).
② Turn on both the transmitter and the receiver, and then the LED of R8FG will start flashing
slowly.
③ There is a black binding button (ID SET) on the side of the receiver. Press the button for more
than 1 second and release, the LED will flash quickly, indicating the binding process is ongoing.
④ When the LED stops flashing and is always on, binding is complete and there will be a signal
tower shown on top of the IPS screen of the transmitter(As shown above). If not successful, the
R8FG INTRODUCTION