RadioLink RC8X - Button Introduction

RadioLink Electronic Limited
www.radiolink.com
7
The USB Type-C port of RC8X can be used to update firmware, copy data, supply power to
image transmission module, and temporarily supply power to RC8X. You can connect the power
supply such as a computer to the Type-C port to supply 5V power to RC8X.
Note: 1. When the USB Type-C port is used to supply power to RC8X, please remove the battery
to avoid over-discharging. 2. The maximum input voltage of the RC8X Type-C port is 5V.
Switch/Knob
Full name
Function
DT1
Digital Trim 1
default steering trim
DT2
Digital Trim 2
default throttle trim
DT3
Digital Trim 3
Default ratio switch
DT4
Digital Trim 4
Default brake rate (brake1)
DL1/PS3
Digital Dial 1
Code switch, Gyro gain
Push Switch 3
Default to turn on/off backlight (can be customized)
PS1
Push Switch 1
Default control CH4, can be programmed
PS2
Push Switch 2
Default control CH5, can be programmed
PS4
Push Switch 4
Default control CH6, can be programmed
PS5
Push Switch 5
Default control CH7, can be programmed
VR
Knob switch
Dial, default control CH3, can be programmed
HOME
Power switch /Switch for quick back to homepage
SS
Steering switch
Default control CH1 to turn left and right
TS
Trigger switch
Default control CH2 go forward or backward
BUTTON INTRODUCTION